Pilz PNOZ m0p base unit not expandable Uživatelský manuál stáhnout pdf (Strana 29)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

6-5

6.3 Preparing for operation

6 Commissioning

6.3Preparing for operation6300Preparing for operation6-

6.3.1 Function test during commissioning

Function test during commissioning6-Verdrahtung_multi_Basis_Betr_Funktionstest_BA

6.3.2 Commissioning the PNOZmulti safety system for the first time

Commissioning the PNOZmulti safety system for the first time6-Verdrahtung_multi_Basis_Betr_erstes_Mal_BA

Procedure:

` Wire the inputs and outputs on the base unit and expansion modules

in accordance with the circuit diagram.

` Cascading output as auxiliary output: Connect the load to CO+ and

A2, see connection example.

` Connect the supply voltage:

– Supply voltage for the units (connector X7):

– Terminal A1: + 24 VDC

–Terminal A2: 0 V

– Supply voltage for the semiconductor outputs (connector X2):

– Terminal 24 V: + 24 VDC

– 0V terminal: 0 V

Note: Supply voltage must always be applied to X2 and X7, even if you

are not using the semiconductor outputs.

6.3.2.1 Load project from chip card

Load project from chip card6-Verdrahtung_multi_Basis_Betr_erstes_Mal_von_Chipkarte_BA_alt

Procedure:

` Insert the chip card containing the current project into the card slot on

the base unit.

` Switch on the supply voltage.

CAUTION!

It is essential to check that the safety devices operate correctly

` after the chip card has been exchanged

` after a project has been downloaded

` when the project has been deleted from the base unit's mem-

ory ("Reset Project" menu)

NOTICE

Chip contacting is only guaranteed if the contact surface is

clean and undamaged. The chip's contact surface should there-

fore be protected from contamination, contact and mechanical

impact such as scratches.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 46 47

Žádné komentáře

Pilz PNOZ m0p base unit not expandable Uživatelský manuál Strana 29