Pilz PNOZ ms3p HTL Uživatelský manuál stáhnout pdf (Strana 23)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

6-3

6.2 Preparing for operation

6 Commissioning

6.2.1.2 Connect the incremental encoder to the speed monitor via an adapter

Connect the incremental encoder to the speed monitor via an adapter 6-Drehzahlwaechter_Betriebsb_Inkremen_ueber_Adapt_HTL_BA

 The adapter (e.g. PNOZ msi6p) is connected between the incremental

encoder and the drive. The output on the adapter is connected to the

RJ-45 female connector on the speed monitor.

 The adapter can also be used without connecting to a drive.

 The signals relevant for the speed monitor are utilised in parallel by

the adapter. The information stated in section 6.2.2.1 and in the

adapter operating manual must be observed when connecting the

supply voltage.

 Supply voltage (12 V – 30 V) to incremental encoder only.

 HTL signals may not be fitted with a terminating resistor.

Fig. 6-2: Connection via adapter and drive

Incremental

encoder

X12

X22

Speed monitor

Drive

Adapter

24 V

0 V

24 V DC

0 V

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Žádné komentáře

Pilz PNOZ ms3p HTL Uživatelský manuál Strana 23