Pilz PSENvip RL D P Uživatelský manuál stáhnout pdf (Strana 83)

7.2 Initial commissioning

7 Commissioning

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

7-2

7.2Initial comm issioning7200Initial commissi oning7-

7.2.1 Align transmitter and receiver

Align transmitter and receiver7-Inbetriebnahme_Erstinbetriebnahme_Ausrichten

Please note the following when aligning the transmitter and receiver:

 Once installed, the transmitter and receiver must be exactly aligned

to each other and to the tip of the upper tool. The vertical and hori-

zontal alignment is performed using adjustment templates and is dis-

played on the receiver.

 The transmitter and receiver must also be aligned after changing ei-

ther the PSENvip transmitter or receiver.

7.2.1.1 Prepare for alignment

Prepare for alignment7-Inbetriebnahme_Erstinbetriebnahme_Ausrichtung_vorbereiten

Please note the following when preparing for alignment:

 Transmitter and receiver must be installed correctly on the press

brake (see Chapter 5, "Installation") and electrically wired (see Chap-

ter 6, "Wiring").

 An upper tool must be fitted to the right and left-hand edge of the

press brake.

 Switch on the supply to the PSENvip.

7.2.1.2 Adjustment templates

Adjustmen t templates7-Inbetriebnahme_Erstinbetriebnahme_Justageschablonen

Two adjustment templates and the information on the display provide

support when aligning the transmitter and receiver.

Please note the different cut-outs around the cross-hair on the two ad-

justment templates. On the left-hand adjustment template in the illustra-

tion below, the cross-hair is located within a square cutout. The different

forms make it easier to secure information about the direction of move-

ment when aligning the transmitter and receiver.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 147 148

Žádné komentáře

Pilz PSENvip RL D P Uživatelský manuál Strana 83