Pilz PSENvip RL D P Uživatelský manuál stáhnout pdf (Strana 103)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

7-19

7.3 Adjustment during tool change

7 Commissioning

Option 2:

 Press the ( ) key to start the Tool Change.

Fig. 7-18: Tool change menu

 1: Tool centre point

 2: Range bar

 3: Adjustment line

 4: Central and rear bending line

 5: No tool identified or vertical position of tool centre point out-

side of the range bar

 6: Receiver insufficiently lit by transmitter

 7: Detected tool class

The adjustment line is automatically tracked to the tool centre point.

Inbetriebnahme_Justage_bei_Werkzeugwechsel_durchführen_2

The vertical position of the tool centre point must be within the range

bar. Once the adjustment line is at the top or bottom of the range bar,

the following symbol appears: .

If the symbol appears on the display, there is a problem with the

lighting of the receiver by the transmitter:

 Check that the transmitter and receiver are aligned correctly. The illu-

minated target area must completely envelop the receiver. If neces-

sary, realign the transmitter (see section entitled "Align transmitter").

 Remove any potential contamination on the lens of the transmitter or

receiver.

SYSTEM OK

OSSD OFF

TOOL CHANGE

Tool class 1

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 156 157

Žádné komentáře

Pilz PSENvip RL D P Uživatelský manuál Strana 103